枪友会

 找回密码
 立即注册
搜索
热搜: 入门 指南 攻略
查看: 2087|回复: 15

[枪械知识] 退弹用手接的要小心了

[复制链接]

180

主题

1924

帖子

1万

积分

老牌枪友

Rank: 3Rank: 3

积分
19722
跳转到指定楼层
楼主
发表于 2020-4-2 21:06 | 只看该作者 回帖奖励 |倒序浏览 |阅读模式

手枪退弹的时候,你是不是用手直接在退弹口把子弹接住?看看下面的文章,子弹会不小心激发,直接在你手里炸了。

https://www.thefirearmblog.com/blog/2017/04/10/potd-watch-hands-unload-show-clear/

POTD: Watch Your Hands When You Unload And Show Clear

Thanks to my friend Scott B. for sharing this story.

A shooter was unloading his handgun when this happened. From what Scott relayed to me, was that the shooter cups the ejection port to catch the round to save time from picking it up off the floor. Now to clarify, this was not a malfunction. It was not a FTF and the primer was never struck. What happened was that during the unloading process the shooter’s hand covers the ejection port. The round most likely ejected into the hand but since the hand was so close to the ejection port it got caught between the slide and barrel.

Take a look at the picture below. You can see the primer lacks any hammer mark. However there is a clear crease from the edge of the slide cutting into the headstamp of the casing. If you look at the photo at the very top, you can see the bullet has a vertical line cut into it as well.
By cupping the round as it ejected out and it getting caught on the slide as the slide tried to close, the round went off in the shooter’s hand.
Here is what Scott relayed to me:
The following is a story relayed to me. I do not have first hand knowledge of this, but I do trust the source.
The pictures are of a recovered case and projectile after a shooter attempted to eject a live round during an unloading evolution. The shooter covered the ejection port with his hand and attempted to capture the live round rather than letting it eject freely from the ejection port. The round was trapped, under pressure of the recoil spring, in-between the edge of the ejection port along the edge of the breach face and the front of the ejection port on the right side of the slide.
There is a noticeable linear denting on the nose of the projectile and an obvious strike point on the rear of the case and the primer. The projectile could not escape and the resulting effect was for the case to burst. The pressure from the burning propellent was absorbed by the shooter’s hand. He will not be able to make this mistake again.
It is a sobering lesson for many shooters. No one ever really believes that this could happen to them.


I have seen some people use this technique in USPSA. I have seen people eject the round and catch it in the air as well. Be careful and pay attention. The scenario above could be considered a sheer accident. However if the shooter did not use that ejection method then there is less likely of a chance such an event would have occurred.


Beware the man with one gun, he knows how to use it.

46

主题

1854

帖子

1万

积分

老牌枪友

Rank: 3Rank: 3

积分
15993
沙发
发表于 2020-4-2 21:20 | 只看该作者
这个和走路时被车撞到概率类似吧?另外我们都是倾斜大力拉机然后伸手抓住空翻的子弹 危险小很多。
回复

使用道具 举报

274

主题

8448

帖子

7万

积分

国宝枪友

更爱吃Ferrero Rocher

Rank: 5Rank: 5

积分
73458

三枪客携枪执照

板凳
发表于 2020-4-2 21:45 | 只看该作者
要让套筒回来正好ejection port的边缘打在底火上,还要有足够的力量打出这么大个坑来(我觉得这得是把套筒锁定了,然后用按下空挂手柄才能实现的),还得正好ejection port的前缘顶在弹头正中间把子弹夹住,弹头还得是平头的或者是空尖的(圆头的9毫米FMJ就更难做到了),我觉得这几率可以赢好几次Power Ball的jackpot了。。。

所以我觉得这个unload的动作如果要彻底保证万无一失,你就每次拉套筒然后手掌去接着子弹的同时,保证套筒拉到头同时右手拇指推上空挂,把套筒锁定,这样子弹要爆只能是你的手太热了,把子弹给cook off了。。。
GLOCK Certified Armorer
回复

使用道具 举报

189

主题

2420

帖子

5万

积分

版主

Rank: 7Rank: 7Rank: 7

积分
55377
地板
发表于 2020-4-2 21:56 | 只看该作者
直接退弹让弹掉地下就好。。我就有朋友炸过手
Team Walther

https://www.instagram.com/cao_shooting/
回复

使用道具 举报

84

主题

790

帖子

1万

积分

老牌枪友

Rank: 3Rank: 3

积分
18396

三枪客认证教员

5#
发表于 2020-4-2 22:48 | 只看该作者
甩帥代價大啊
回复

使用道具 举报

6

主题

1420

帖子

2万

积分

元老枪友

Rank: 4

积分
23531

三枪客认证教员

6#
发表于 2020-4-2 23:28 | 只看该作者
退弹就掉地上好了
My Life's Getting Better!
回复

使用道具 举报

632

主题

4750

帖子

5万

积分

国宝枪友

Rank: 5Rank: 5

积分
50654

三枪客携枪执照

7#
发表于 2020-4-3 04:03 | 只看该作者
有爱 "玩儿票" 的主儿 ... 猛拉 Slide 退堂, 还把 support hand 堵在 Breach 外, 准备接拉出来子弹 ... 万一 Ejector 顶了 Primer... 手被炸的可能极大.

最好的办法还是枪口朝下, 轻拉 Slide, 只用 Extractor 的功能 ... Not  Ejector ...
LIFE IS GOOD
回复

使用道具 举报

17

主题

515

帖子

1万

积分

老牌枪友

Rank: 3Rank: 3

积分
13489
8#
发表于 2020-4-3 04:49 | 只看该作者
另外我们都是倾斜大力拉机然后伸手抓住空翻的子弹 危险小很多。+1
HK VP9 LE
Sig Sauer P938 Equinox
Smith & Wesson Model 60-14;
Smith & Wesson 637 .38SPL +P, Performance Center Super Tuned
回复

使用道具 举报

10

主题

204

帖子

6195

积分

高级枪友

Rank: 2

积分
6195
9#
发表于 2020-4-3 05:24 | 只看该作者
危险随时出现啊
回复

使用道具 举报

33

主题

4314

帖子

2万

积分

元老枪友

Rank: 4

积分
22850
10#
发表于 2020-4-3 09:26 | 只看该作者
回复

使用道具 举报

366

主题

3256

帖子

2万

积分

元老枪友

Rank: 4

积分
21669
11#
发表于 2020-4-3 10:34 | 只看该作者
用手扣住貌似很不好操作啊。我也是向来拉栓,子弹抛向空中,然后伸手抓住。我觉得这样才酷啊
回复

使用道具 举报

155

主题

6999

帖子

6万

积分

国宝枪友

Straight Shooter

Rank: 5Rank: 5

积分
66462

开坛元勋NRA终身会员三枪客认证教员携枪执照

12#
发表于 2020-4-3 10:57 | 只看该作者
本帖最后由 doublepar 于 2020-4-3 10:58 编辑

每次都很猥琐地让弹掉地上 ...... 这个时刻需要集中注意的是枪!
抓弹有危险,耍帅须谨慎。
回复

使用道具 举报

38

主题

6500

帖子

3万

积分

元老枪友

Rank: 4

积分
31173
13#
发表于 2020-4-3 13:13 | 只看该作者
耍酷的代价啊
Fight to your last cartridge,fight with your bayonets, no surrender, fight to the death!
回复

使用道具 举报

7

主题

207

帖子

9428

积分

老牌枪友

Rank: 3Rank: 3

积分
9428

认证教员

14#
发表于 2020-4-3 14:31 | 只看该作者
这个蛋壳崩了是因为弹头被卡住了,真是捏在手里放心不会炸,可能烧伤手掌而已,不影响耍帅
回复

使用道具 举报

8

主题

142

帖子

1794

积分

中级枪友

Rank: 1

积分
1794
15#
发表于 2020-4-3 15:31 | 只看该作者
delay fire会不会仍有风险
别回来变身空爆榴弹
回复

使用道具 举报

4

主题

3045

帖子

1万

积分

老牌枪友

Rank: 3Rank: 3

积分
14664
16#
发表于 2020-4-3 15:54 | 只看该作者
不是小概率事件?
回复

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

触屏版|枪友会

GMT-8, 2024-4-24 21:55 , Processed in 0.032390 second(s), 19 queries .

快速回复 返回顶部 返回列表