|
本帖最后由 Serafint 于 2018-1-19 09:50 编辑
18年7月之前可以自己随意编一个Series#,18年7月之后要向DOJ交钱申请一个Series#
“If you engrave a serial number of your choosing into your completed 80% lower prior to Jul 1, 2018, you will not be affected by this law and you do not need to notify any government agency that you built a firearm. In other words, you can make up any serial number you want (as long as it meets ATF's definition of a serial number), engrave it on your receiver, and this will satisfy California’s legal requirement. You do not need to apply to the state, or tell them what your serial number is. Your lower can still legally remain completely off the radar. The important thing is you MUST engrave your serial number before July 1, 2018 to take advantage of this benefit.”
https://www.80percentarms.com/pages/faq
另外ATF的要求是a minimum depth of .003 inch and in a print size no smaller than 1/16 inch
polymer 80 的 PF940C和PF940V2符合要求, PF940V1的plate不够.003 inch
我是直接在刻字那里买的PF940C
https://www.atomicengraving.com |
|