Beretta 92fs safety removal

loveast · 发表于 2020-4-29 15:35

本帖最后由 loveast 于 2020-4-29 16:11 编辑

I like my beretta 92fs, it's my first gun. But I hate it's safety, with DA/SA, no saftey is necessary to me.
I want to convert it to G only, but save the cost, I already spent too much on it.
Here you go
Check youtube on how to disassemble the safety.
I grinded off a small part of the slide at the left side, it's smooth now, so no grove to hold it in safe any more.
Cut off small part of the safety lever at the right side, so the right side detent will push the lever up when in safe position, which is after decocker.
(For this part, if your cut off is too small, the gun will rendered inoperatable after decocker - the safe is on, you'll have to push the safety lever up.)
Added a small collar to the right side detent to increase the spring tension.
Check the video, after decocking, the safety lever doesn't go back completely, but after pulling the trigger, it will go back right away.
https://youtu.be/zoap_HbJekU

The 3rd pic is after decocking, hold by finger. The 4th pic is in normal safety off position. Hope you can find out how much and which angle to cut off.