|
对这个也有点兴趣,刚刚看了看review,但是好像是塑料的
“I was looking for an inexpensive shooting bench rest to sight in a new scope for my rifle. Considering how infrequently it would be used, I really didn't want to spend a lot of money. This rest fit the bill. It came unassembled, but assembly took about 5 minutes, with 5 screws and 4 thumb-tightened bolts (for the bridge connecting the front and rear rest). It functions as described, and I've used it with both pistols and rifles at this point.
PROS:
- Easily raise or lower the front rest (and lock at desired height)
- Will not damage the finish of your firearm
- Great price!
CONS:
- It's plastic, so it's light. Moves very easily, even with light-recoil weapons.
- Rear rest is too low, in my opinion...although you could add a sandbag or padding
- Rear rest also doesn't work well with some collapsible stocks
- Bridge must be removed if using high-capacity magazines (i.e. AR-15 w/ 30-rnd mag)
- With bridge removed, the stability of the front and rear rest is dramatically reduced
- Have to fiddle with it to lay flat...tends to bow a bit in the middle.
But my sight is now zeroed in, so it did it's job.”
|
|
Vault Dweller: I have a crime to report!
Deputy Fry: Really? I, uh, you should talk to the Sheriff. I can't leave my post right now. I've got to... uh, fend off raiders that might come. Plus, I'm not very good with reports.
|