Sig p226 sight picture

icecoffeetea · 发表于 2014-4-8 22:08

Hi,

I am new to Sig p226. I used the #2 sight picture as attached. However, my shooting was always 2-3 inches low from the center of the target at 7 yards distance.
I confirmed using a laser bore sight in the barrel that #2 sight overlaps with the laser dot at 7 yards. I took a video of my shooting as well as dry firing with a laser attached. I didn't notice obvious trigger poll. How do you aim your p226? Any suggestion? Thanks.

SemperFortis · 发表于 2014-4-8 23:16

Try using a heavier load with a slower bullet, it will bring your poi up. For example 147gr.

kisskaren · 发表于 2014-4-8 23:26

以不变应万变 2

alex · 发表于 2014-4-9 02:54

sig一般是3.......

Cyberx1911 · 发表于 2014-4-9 04:40

Sig uses combat sights. Try sight picture 3. Also 7 yards is too close so hitting low is normal.

PhilipJ · 发表于 2014-4-9 05:27

本帖最后由 PhilipJ 于 2014-4-9 08:30 编辑

试试ball and dummy，看看打实弹的时候有没有扣扳机/recoil anticipation问题。

thelittleone · 发表于 2014-4-9 05:38

3号。

wolflj98 · 发表于 2014-4-9 05:57

3. Sig or Europe guns use combat sight. This is explained in SIG customer service website. It will be more accurate if you try 3.

alex · 发表于 2014-4-9 06:00

NCL 发表于 2014-4-9 05:54
为啥too close会hitting low？

彈道是拋物線。。。

alex · 发表于 2014-4-9 06:15

NCL 发表于 2014-4-9 06:05
哦，你是说zero的距离对应的是抛物线顶端？

25yd zero的话应该还没到顶。。。。。。。

Cyberx1911 · 发表于 2014-4-9 06:29

NCL 发表于 2014-4-9 05:54
为啥too close会hitting low？

画得不好

Cyberx1911 · 发表于 2014-4-9 06:31

10米往后打用3瞄准基本POI和POA就差不了太远

alex · 发表于 2014-4-9 06:57

Cyberx1911 发表于 2014-4-9 06:29
画得不好

超长mag,禁了。

fat_tony · 发表于 2014-4-9 08:15

我也确认一个，SIG是3号

jack666 · 发表于 2014-4-9 08:46

kisskaren 发表于 2014-4-8 23:26
以不变应万变 2

哈哈哈你太逗了

wansir · 发表于 2014-4-9 09:06

主要还是Recoil anticipation吧.

xchen57 · 发表于 2014-4-9 16:14

no matter which sight pictures you apply, 2-3 inches constantly low is more or less about your shooting technique. I would suggest to load 1 or 2 dummy "snap caps" in the magazine as well as others, fire it, and see if you break down your wrist. aka. anticipating recoil.

icecoffeetea · 发表于 2014-4-9 22:09

多谢众多建议。周么加上laser再去靶场是一下。不过刚看到sig official site Q&A https://www.sigsauer.com/CustomerService/Faq.aspx.
"My SIG SAUER pistol is not accurate. Why? What should I do?
All SIG SAUER production duty/combat pistols are set up to use a "combat" sight picture. This is where the front sight completely covers the bulls eye of the target. Using a six o'clock ("pumpkin on a post") or center mass ("half'n'half") sight picture will result in low impact. SIG SAUER, Inc sights in all non-sporting and non-target pistols for 2.5 inch groupings @ 15 yards. If you are still having trouble please contact Customer Service for further help and instruction. Please have your serial number ready. There are also very helpful free Internet sites that cover pistol group analysis. "

It sounds like sig is suggesting sight picture "C" as in the attached picture?
MK25团购,新p226r兄弟们,大侠们确认一下？

kisskaren · 发表于 2014-4-9 22:19

C遮挡太多而且B更符合多数射手的本能sight pic，眼睛聚焦前瞄但对模糊的目标的移动倒下等也是有感知的。
对于实用自卫距离，他们的弹着差异可以忽略，养成一致的习惯最好，紧张时刻操心的事情很多，没空想清楚手里拿的是glock sig 还是1911

		自动登录	找回密码
密码			立即注册

[实践射击] Sig p226 sight picture

开坛元勋

认证教员

NRA终身会员

携枪执照

三枪客